Bad vibration when excellerating at 65+

[meekial]

Hey everyone I finally have my 1g turbo swap up and running very well and most of the bugs worked out! However, when I was driving it today everytime that I would excelerate at 65+ it would vibrate REALLY bad. But when I would press the clutch in the vibration would stop completely. So basically it just vibrates when I am under a load or decellerating, and again it will not vibrate when I have the clutch pedal down. Could this be an engine mount?

[stonedracer]

could be. my suggestion is alignment, un-balanced tires, or tie-rod ends.

[FenixTX717]

Possibly an axle. But process of elmination check the above as well.

[meekial]

could be. my suggestion is alignment, un-balanced tires, or tie-rod ends.

It goes away when I push the clutch in.

[HANZwitA93]

id drop the tranny and see which bearing looks like shit

[meekial]

it vibrates 3,4,5 just when i go over 65 when I am accelerating and decelerating and I am not touching the clutch. It stops once when I push the clutch in even if I am doing 100+

[meekial]

could be. my suggestion is alignment, un-balanced tires, or tie-rod ends.

actually the more I think about it, the more I think your right. I just had a ball joint replaced and didnt get it aligned and the tires I got off of a different car. So now I think I am going to get an alignment and tire balancing done. lol

[stonedracer]

actually the more I think about it, the more I think your right. I just had a ball joint replaced and didnt get it aligned and the tires I got off of a different car. So now I think I am going to get an alignment and tire balancing done. lol

check your tie rod ends too. i had the exact same thing and it turned out to be those.

[meekial]

well I finally figured out what it was! It was the drivers side cv shaft! that thing was friggin shot to hell lol. once I replaced it was good to go :D thanks again for your help and assistance everyone I would probably still be dead in the water if it werent for you all!