haase's 420a turbo project

[HANZwitA93]

well after a while of working on this project, i actually remembered to bring my camera and take some pics to update you guys on how its going....

well this is where we are at as of now

down pipe welded up and o2 housing mounted
http://i891.photobucket.com/albums/ac115/DSM_hanz/018.jpg

uicp in place and ran to the side mount
http://i891.photobucket.com/albums/ac115/DSM_hanz/017.jpg

smic in place
http://i891.photobucket.com/albums/ac115/DSM_hanz/016.jpg

bov mount right next to smic on the under side
http://i891.photobucket.com/albums/ac115/DSM_hanz/015.jpg

boost and oil pressure mounted and wires/vac line ran(getting prosport boost and volt of water temp also)
http://i891.photobucket.com/albums/ac115/DSM_hanz/014.jpg

more wires
http://i891.photobucket.com/albums/ac115/DSM_hanz/012.jpg

the turbo itself
http://i891.photobucket.com/albums/ac115/DSM_hanz/008.jpg

we also have the 255 fuel pump in. also have to get the fmu and a few more small things in and then it should be done

[zerepdivad]

I'd fix that fuse tapping and wire them up properly. But looks like a decent start.

[HANZwitA93]

it will work for now, i dont know much about the 2g interior coming apart to get at wires but i did what i could for now.
and i really didnt have my wiring stuff with me

[zerepdivad]

Parking Lights GREEN/WHITE (+) DR.KICK

use that wire to trigger a relay that turns on all of your gauges with the parking lights.

[HANZwitA93]

i spliced in to the green and white wire on the dimmer switch.....ive done gauge wiring befor

[HANZwitA93]

and no i didnt just leave the wires laying there

[zerepdivad]

Fusetapping that way is just kind of halfassed, and has always really bothered me. and wrapping wire around a bolt and screwing it in also. but eh if it works for you whatever. good luck with the build make sure you post up some videos.

[northsydryd]

are those couplers from the hardware store? you can plan on changing those realy quik when you get this things running.they dont liek heat at all

[Integra 26R]

Yea and then when you go and pull the wires back out the plug is too wide and makes crappy contact with the fuse and then things don't work. And it looks like two wires are under different sides on the same fuse so one of those wires isn't protected. And yea those couples just blow open after awhile.

[duwackerTSi69]

You can get decent wiring info from BullDogsecurity.com it's all free too. Although looks like you have a good start so far. For sure you want to wire in the gauges properly.. Good luck on the build man