PDA

View Full Version : greedy turbo timer issue

crossbreed
04-26-2010, 11:55 AM
I can't figure out how to hook this beast up right. The online manual for it says to hook my purple wire to my cars ecu speed sensor but it's a 92. Do they even have a speed sensor. I hooked it up where it said to anyway with no results. And i have to turn it on after the car is running. It should do this by itself. Well, one of my problems i think it could be is i don't have power to any of my dome lights of a solid 12v to my radio. To store memory. can this be my issue. I picures are needed i'll post them.
Jordan525
04-26-2010, 01:59 PM
why not just get the harness that plugs in underneath the steering column
crossbreed
04-26-2010, 08:13 PM
I'm cheap. But shouldn't start the count down when the e brake is pulled
Integra 26R
04-27-2010, 12:31 AM
When you turn off the car if the parking brake is up and the wire is attached to it.
crossbreed
04-27-2010, 10:55 AM
yeah i have the wire attached. it should start the count when i pull the brake and shut it off.
steve
04-27-2010, 03:28 PM
Yes 1G's have a speed sensor. It's in the speedometer not in the transmission. It comes out to pin 11 on the DLC as well as going to the ECU, cruise control and I think the TCU on an automatic.
FenixTX717
04-27-2010, 04:05 PM
Save yourself all the trouble and get the harness! That way you don't hack up all your wires either, besides it's like 7-15 bucks last time I was looking a few years ago :D
xxxfrankenstein406xxx
04-27-2010, 06:41 PM
Save yourself all the trouble and get the harness! That way you don't hack up all your wires either, besides it's like 7-15 bucks last time I was looking a few years ago :D

$23 shipped i think
crossbreed
04-27-2010, 08:04 PM
i have the timer wired but in order for it to work properly i need to get the speed signal. do any of you know what pin on the ecu i need to tap.
crossbreed
04-27-2010, 08:06 PM
i have the timer wired but in order for it to work properly i need to get the speed signal. do any of you know what pin on the ecu i need to tap.

and there is no harness to just plug in for the speed sensor wire.
xxxfrankenstein406xxx
04-27-2010, 09:20 PM
let me see if i have it from putting in a safc

i have rpm wire :/
Integra 26R
04-28-2010, 06:41 AM
The reed switch is your speedometer. Pin 18 connector C-66 on the ecu (the big one). It says YW for a wire color whatever color that is.

http://i16.photobucket.com/albums/b31/crx26r/speed2.png
steve
04-28-2010, 08:58 AM
It says YW for a wire color whatever color that is.

Yellow with White stripe.
crossbreed
04-28-2010, 02:23 PM
The reed switch is your speedometer. Pin 18 connector C-66 on the ecu (the big one). It says YW for a wire color whatever color that is.

http://i16.photobucket.com/albums/b31/crx26r/speed2.png

looks like i was off by one pin. I'll rewire and see how it goes. Thanks for the great info.